HEADLIGHT ASSEMBLY (for HID Headlight) REMOVAL

CAUTION:

Make sure that the headlight control ECU sub-assembly LH is not connected or hot before removing the headlight control ECU sub-assembly.

Tech Tips

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PRECAUTION

Note

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE RADIATOR GRILLE
1. Remove the 2 clips and 2 screws.
2. Text in Illustration
  
  *1 Protective Tape
  
  Put protective tape around the radiator grille.
3. Detach the 6 claws and remove the radiator grille.
REMOVE FOG LIGHT COVER LH
1. Text in Illustration
  
  *1 Protective Tape
  
  Put protective tape around the fog light cover.
2. Using the screwdriver, detach the 8 claws and remove the fog light cover.
  
  Tech Tips
  
  Tape the screwdriver tip before use.
REMOVE FOG LIGHT COVER RH

Tech Tips

Use the same procedure described for the LH side.
REMOVE FRONT BUMPER COVER
1. Remove the 6 screws and 3 clips.
2. Put protective tape around the front bumper cover.
3. Remove the 2 screws, 2 bolts and 5 clips.
  
  Text in Illustration
  
  *1 Protective Tape
4. w/ Headlight Cleaner System:
  
  Disconnect the headlight cleaner hose, and then drain the washer fluid.
  
  Tech Tips
  
  Use a container to collect the washer fluid.
5. w/ Fog Light:
  
  Disconnect the 2 fog light connectors.
6. Detach the 8 claws and remove the front bumper cover.
REMOVE HEADLIGHT ASSEMBLY LH
1. Text in Illustration
  
  *1 Protective tape
  
  Put protective tape around the headlight assembly LH.
2. Remove the 3 screws and bolt.
3. Disconnect the connectors and remove the headlight assembly LH.