CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing it Click here.


  1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

    A01J7DR

    1. Temporarily install the sensor with the 3 bolts.

      CAUTION:


      • If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the airbag sensor, make sure that the SRS wiring does not interfere with other parts and is not pinched between other parts.

    2. Tighten the 3 bolts.

      Torque:
      17.5 N*m  { 179 kgf*cm, 13 ft.*lbf }

    3. Check that there is no free play in the installation parts of the sensor.

    4. Connect the sensor connector.

    5. Check that the waterproof sheet is properly set.

  2. INSTALL CONSOLE BOX ASSEMBLY

    A01J4XBE01
    Text in Illustration
    *1 Screw
    *2 Bolt
    *3 Clip

    1. Install the console box with the 4 screws and 2 bolts.

    2. Install the 2 clips.

  3. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. Attach the 12 claws to install the upper console panel.

      A01J7INE01
      Text in Illustration
      *A for 2WD *B for 4WD

  4. INSTALL TRANSFER SHIFT KNOB SUB-ASSEMBLY (for 4WD)

  5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  7. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

  8. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.