CENTER AIRBAG SENSOR ASSEMBLY REMOVAL

CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing it Click here.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)

  3. REMOVE TRANSFER SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)

  4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. Detach the 12 claws and remove the upper console panel.

      Note

      Be careful not to damage the instrument panel and console box with the claws of the console panel.

      A01J7INE01
      Text in Illustration
      *A for 2WD *B for 4WD

  5. REMOVE CONSOLE BOX ASSEMBLY

    A01J4XBE01
    Text in Illustration
    *1 Screw
    *2 Bolt
    *3 Clip

    1. Remove the 4 screws and 2 bolts.

    2. Using a clip remover, remove the 2 clips and console box.

  6. REMOVE CENTER AIRBAG SENSOR ASSEMBLY

    A01J7DR

    1. Disconnect the sensor connector.

    2. Remove the 3 bolts and sensor.