BRAKE SYSTEM PRECAUTION

Note


  • Take extra care to replace each part properly. Improper installation or repair could affect the performance of the brake system and cause a driving hazard.

  • It is very important to keep the brake system parts and the work area clean when repairing the brake system.

  • If the vehicle is equipped with a mobile communication system, refer to the Precautions in the INTRODUCTION section Click here.

  • Care must be taken when using magnets as they could affect the performance of the speed sensors.

  • Since the brake line is one of the critical safety-related parts, be sure to disassemble the components if a brake fluid leak is found. If any abnormality is found, replace the component with a new one.

  • When removing brake components, cover the brake tube connections to prevent foreign matter such as dust or dirt from entering the tubes.

  • Do not damage or deform the brake tubes when removing or installing them.

  • When installing a brake tube grommet to the body, ensure that the brake tube passes through the center of the grommet.

  • When installing a brake tube or flexible hose, ensure that it is not twisted or bent.

  • If the cap of the flexible hose does not match the groove on the bracket, twist the hose slightly to insert it.

  • Do not reuse a clip removed from a flexible hose.

  • Flexible hoses must be free from absorber oil, grease, etc.

  • When installing a brake tube to a plastic clamp, ensure that the brake tube is not loose or being pinched.

  • Do not reuse a clip or plastic clamp removed from a flexible hose.

  • After installing a brake tube and flexible hose, ensure that they do not interfere with any other components.

  • Do not allow brake fluid to adhere to any painted surface such as the vehicle body. If brake fluid leaks onto any painted surface, immediately wash it off.

  • A01J4BEE21

    Follow these procedures when disconnecting the flexible hose and brake tube.


    1. Remove the clip.

    2. Hold the flexible hose with a wrench. Using a union nut wrench, disconnect the brake tube without deforming the tube.

  • Follow these procedures when connecting the flexible hose and brake tube.


    1. Hold the flexible hose with a wrench. Using a union nut wrench, connect the brake tube without deforming the tube.

    2. Install a new clip.

  • A01J6OF

    Follow these procedures when connecting the brake tube and 2-way.


    1. Support the 2-way to prevent deformation to the brake tube and connect the brake tube to the 2-way with a union nut wrench.

    2. Support the 2-way to prevent deformation to the brake tube and install the bolt to fix the 2-way to the body.