REAR SPEED SENSOR (for 4WD and Pre-Runner) INSTALLATION


  1. INSTALL SKID CONTROL SENSOR CLAMP


    1. A01J5DS

      Install the skid control sensor clamp with the bolt.

      Torque:
      32 N*m  { 326 kgf*cm, 24 ft.*lbf }

      Note

      Make sure the clamp rotation stopper touches the installation position.

  2. INSTALL REAR SPEED SENSOR RH


    1. Install the speed sensor with the bolt.

      A01J6J4
      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

      • While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.

      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.

    2. Attach the 6 clamps.

      Note

      When attaching the clamps, do not twist the wire harness.

    3. Connect the connector.

      Note


      • Pass the sensor connector between the brake tube and axle housing before connecting it to the wire harness connector on the vehicle.

      • Securely connect the connector.

      • When connecting the connector, do not twist the wire harness.

    4. Attach the connector to the skid control sensor clamp.

  3. INSTALL REAR SPEED SENSOR LH


    1. Install the speed sensor with the bolt.

      A01J4JS
      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

      • While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.

      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.

    2. Attach the 3 clamps.

      Note

      When attaching the clamps, do not twist the wire harness.

    3. Connect the connector.

      Note


      • Securely connect the connector.

      • When connecting the connector, do not twist the wire harness.

    4. Attach the connector.

  4. INSTALL REAR WHEEL

    Torque:
    105 N*m  { 1071 kgf*cm, 77 ft.*lbf }

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. CHECK SPEED SENSOR SIGNAL


    1. w/ Rear Differential Lock:

      Check the speed sensor signal Click here.

    2. w/o Rear Differential Lock:

      Check the speed sensor signal Click here.