REAR SPEED SENSOR (for 4WD and Pre-Runner) REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE REAR WHEEL

  3. REMOVE REAR SPEED SENSOR LH


    1. Disconnect the connector.

      A01J4JS

    2. Detach the connector.

    3. Detach the 3 clamps.

    4. Remove the bolt and speed sensor.

      Note

      Keep the sensor tip and sensor installation hole free from foreign matter.

  4. REMOVE REAR SPEED SENSOR RH


    1. Detach the connector from the skid control sensor clamp.

      A01J6J4

    2. Disconnect the connector.

    3. Detach the 6 clamps.

    4. Remove the bolt and speed sensor.

      Note

      Keep the sensor tip and sensor installation hole free from foreign matter.

  5. REMOVE SKID CONTROL SENSOR CLAMP


    1. A01J5DS

      Remove the bolt and skid control sensor clamp.