FRONT SPEED SENSOR (for 4WD and Pre-Runner) REMOVAL

Tech Tips


  • The procedures listed below are for the LH side.

  • Other than areas where instructions are provided, use the same procedures for the LH side and RH side.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT WHEEL

  3. REMOVE FRONT SPEED SENSOR LH


    1. Disconnect the connector.

      A01J6FYE01

    2. Detach the 2 clamps and connector.

    3. A01J5GJE01

      Detach the 2 clamps.

    4. A01J50WE01

      Detach the clamp.

    5. Remove the 2 bolts and 2 harness clamps.

    6. A01J5WLE01

      Detach the 2 clamps.

    7. Remove the bolt and harness clamp.

    8. Remove the bolt and speed sensor.

      Note

      Keep the sensor tip and sensor installation hole free from foreign matter.

  4. REMOVE SKID CONTROL SENSOR CLAMP


    1. Remove the bolt and skid control sensor clamp from the knuckle.

      A01J4H8E01