REAR COIL SPRING REMOVAL

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.


  1. REMOVE REAR WHEEL

  2. DISCONNECT REAR SPEED SENSOR LH

  3. REMOVE TAILPIPE ASSEMBLY


    1. Remove the tail exhaust pipe for 1GR-FE Click here.

    2. Remove the tail exhaust pipe for 2TR-FE Click here.

  4. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. Disconnect No. 3 parking brake cable Click here.

  5. DISCONNECT REAR BRAKE TUBE FLEXIBLE HOSE

    A01J3KEE01

    1. Using SST, disconnect the brake line from the flexible hose.

      SST
      09023-00101

    2. Using a screwdriver, remove the clip.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Remove the flexible hose from the 3 way joint.

  6. DISCONNECT REAR SHOCK ABSORBER ASSEMBLY

    A01J2ZC

    1. Support the axle housing.


      1. Jack up and support the vehicle's frame on stands.

      2. Lower the axle housing until the coil spring tension is free, and maintain this position.

    2. Remove the nut and 2 retainers.

    3. A01J7LO

      Remove the 2 bolts.

    4. Disconnect the shock absorber and 2 bushes from the axle housing and frame.

    5. Remove the lock nut, bracket, 3 retainers and 2 cushions.

  7. REMOVE REAR COIL SPRING


    1. Slowly lower the rear axle housing.

      Note

      Be careful not to snap the brake line or parking brake cable.

    2. While lowering the axle housing, remove the coil spring and insulator.