PROPELLER SHAFT ASSEMBLY INSPECTION


  1. INSPECT PROPELLER SHAFT AND INTERMEDIATE SHAFT (for Pre-Runner)


    1. A01J6DZE02

      Using a dial indicator, measure the propeller shaft and intermediate shaft runout.

      Maximum Runout
      Item Specified Condition
      Propeller shaft 0.3 mm (0.0118 in.)
      Intermediate shaft 0.5 mm (0.0197 in.)

      If the shaft runout is more than the maximum, replace the shaft.

  2. INSPECT REAR PROPELLER SHAFT ASSEMBLY (for 4WD)


    1. A01J4GL

      Using a dial indicator, measure the propeller shaft runout.

      Maximum runout
      0.3 mm (0.0118 in.)

      If the shaft runout is more than the maximum, replace the propeller shaft.

  3. INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY


    1. Check the spider bearings for wear or damage.

    2. Check each spider bearing's axial play by turning the yoke while holding the shaft tightly.

      Maximum bearing axial play
      0 to 0.05 mm (0 to 0.00197 in.)

      If the bearing axial play is more than the maximum, replace the spider bearing.

  4. INSPECT CENTER NO. 1 SUPPORT BEARING ASSEMBLY (for Pre-Runner)


    1. A01J6ZEE01

      When turning the center bearing with your hand, check that it turns smoothly without catching, and that there are no cracks or damage.

      If there are any defects, replace the center bearing.

      If there is any damage to the lip of the center bearing case, replace it.