TRANSFER OIL INSPECTION


  1. CHECK TRANSFER OIL


    1. Remove the case plug (for filler) and gasket.

    2. A01J60OE01

      Check that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole.

      If the result is not as specified, add Hypoid gear oil.

      Oil type
      Hypoid gear oil API GL-5 or equivalent
      Recommended Viscosity
      SAE 75W-90
      Standard capacity
      1.4 liter (1.5 US qts, 1.3 Imp. qts)

      Note


      • After changing the oil, drive the vehicle and check the oil level again.

      • Too much or too little oil will lead to transfer problems.

    3. When the oil level is too low, check for oil leakage.

    4. Install a new gasket into the case plug (for filler) and then tighten the plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

  2. ADD TRANSFER OIL


    1. Remove the case plug (for filler) and gasket.

    2. Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the case plug (for filler) hole.

      Note


      • When adding oil, pour it slowly.

      • Add oil a little at a time, waiting several minutes between each addition of oil.

    3. Wait approximately 5 minutes and check that the oil level has not changed.

    4. Install a new gasket and the case plug (for filler).

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }