CLUTCH UNIT INSTALLATION


  1. INSTALL INPUT SHAFT FRONT BEARING (for 1GR-FE)

    A01J4HYE03

    1. Using SST and a hammer, tap in a new bearing.

      SST
      09304-12012

      Tech Tips

      After installing the bearing to the hub, make sure that it rotates smoothly.

    2. Install 2 new bolts Click here.

  2. INSTALL INPUT SHAFT FRONT BEARING (for 2TR-FE)

    A01J4HYE03

    1. Using SST and a hammer, tap in a new bearing.

      SST
      09304-12012

      Tech Tips

      After installing the bearing to the hub, make sure that it rotates smoothly.

    2. Install 2 new bolts Click here.

  3. INSTALL CLUTCH DISC ASSEMBLY

    A01J67XE03

    1. Insert SST into the clutch disc. Then insert SST (together with the clutch disc) into the flywheel.

      SST
      09301-00110

      Note

      Make sure not to insert the clutch disc facing the wrong direction.

  4. INSTALL CLUTCH COVER ASSEMBLY


    1. A01J6DFE03

      Align the matchmarks on the clutch cover and flywheel.

    2. Tighten the 6 bolts as described below.


      1. Determine the first bolt to be tightened by choosing the bolt closest to the knock pin.

      2. Uniformly tighten the 6 bolts in diametrically opposite pairs relative to the position of the first bolt. Use the illustration as a reference.

        Torque:
        19 N*m  { 195 kgf*cm, 14 ft.*lbf }

    3. Lightly move SST up and down, and right and left.

      SST
      09301-00110

    4. Check that the disc is in the center, and then tighten the bolts.

  5. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY


    1. A01J55IE01

      Using a dial indicator with roller instrument, measure the diaphragm spring tip alignment.

      Maximum misalignment
      0.5 mm (0.0197 in.)

      • A01J5C7E03

        If the misalignment is greater than the maximum, use SST to adjust the diaphragm spring tip alignment.

      SST
      09333-00013

  6. INSTALL RELEASE FORK SUPPORT


    1. Install the release fork support to the manual transmission unit.

      Torque:
      47 N*m  { 479 kgf*cm, 35 ft.*lbf }

  7. INSTALL RELEASE BEARING HUB CLIP


    1. Install the release bearing hub clip to the release bearing.

  8. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY

    A01J39JE03

    1. Apply Multemp 8158 Grease or equivalent to the following areas:


      • The contact surfaces of the release fork and release bearing hub.

      • The contact surfaces of the release fork and push rod.

      • The pivot points of the release fork.

        Grease
        Multemp 8158 Grease or equivalent

    2. Install the release fork to the release bearing.

  9. INSTALL CLUTCH RELEASE BEARING ASSEMBLY


    1. A01J3MFE01

      Apply clutch spline grease to the input shaft spline.

      Grease
      Toyota Genuine Clutch Spline Grease or equivalent

    2. Install the release fork (with release bearing) to the manual transmission.

      Note

      After the installation, move the fork forward and backward to check that the release bearing slides smoothly.

  10. INSTALL CLUTCH RELEASE FORK BOOT

  11. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY

    for R150 manual transmission: Click here.

    for R150F/R151F manual transmission: Click here.