OIL PUMP REASSEMBLY


  1. INSTALL FRONT OIL PUMP OIL SEAL

    A01J6XYE01

    1. Using SST and a hammer, install a new oil seal.

      SST
      09350-30020   ( 09351-32140 )

      Tech Tips

      The oil seal end should be flush with the outer edge of the pump body.

    2. Coat the oil seal lip with MP grease.

  2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY


    1. Place the oil pump body on the torque converter clutch.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR

    A01J6ZWE01

    1. Coat the driven gear with ATF.

    2. Install the driven gear to the oil pump body.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR

    A01J3UWE01

    1. Coat the drive gear with ATF.

    2. Install the drive gear to the oil pump body.

  5. INSTALL FRONT OIL PUMP BODY O-RING

    A01J6ZPE01

    1. Install a new O-ring to the oil pump body.

  6. INSTALL STATOR SHAFT ASSEMBLY

    A01J4DME01

    1. Set the stator shaft on the oil pump body while aligning the bolt holes.

    2. Install the 14 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  7. INSTALL CLUTCH DRUM OIL SEAL RING

    A01J6UPE03

    1. Coat the 3 oil seal rings with ATF.

    2. Squeeze the ends of the 3 oil seal rings together with an overlap distance of 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

      Note

      Do not over-spread the ring ends.

      Tech Tips

      After installing the oil seal rings, check that they rotate smoothly.

  8. INSPECT OIL PUMP DRIVE GEAR ROTATION

    A01J3XHE01

    1. Make sure the drive gear rotates smoothly.

    2. Remove the oil pump assembly from the torque converter.

  9. INSTALL FRONT OIL PUMP BODY O-RING

    A01J2Y9E01

    1. Install the O-ring to the oil pump assembly.