TRANSMISSION WIRE INSTALLATION


  1. INSTALL TRANSMISSION WIRE

    A01J32Y

    1. Install a new O-ring to the transmission wire.

    2. Install the transmission wire with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    3. Connect the transmission wire connector.

  2. CONNECT TRANSMISSION WIRE

    A01J331E03

    1. Connect the 7 connectors to the solenoid valves.

    2. Install the clamp with the 2 bolts.

      Torque:
      10 N*m  { 100 kgf*cm, 7 ft.*lbf, for bolt A }
      11 N*m  { 110 kgf*cm, 8 ft.*lbf, for bolt B }

      Tech Tips

      Each bolt length is indicated below.

      Bolt length
      36 mm (1.42 in.) for bolt A
      12 mm (0.47 in.) for bolt B

    3. Connect the ATF temperature sensor.

  3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

    A01J5WWE01

    1. Install a new O-ring and oil strainer with the 4 bolts.

      Torque:
      10 N*m  { 100 kgf*cm, 7 ft.*lbf }

  4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    A01J7BGE01

    Tech Tips

    Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.


    1. Install the oil pan with the 20 bolts.

      Torque:
      4.4 N*m  { 45 kgf*cm, 39 in.*lbf }

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  6. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

  7. ADD AUTOMATIC TRANSMISSION FLUID


    1. Add automatic transmission fluid Click here.

  8. INSPECT AUTOMATIC TRANSMISSION FLUID


    1. Inspect the automatic transmission fluid Click here.