FLOOR SHIFT ASSEMBLY INSTALLATION


  1. INSTALL FLOOR SHIFT ASSEMBLY

    A01J69PE03

    1. Install the floor shift with the 4 bolts.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

      Note

      Tighten the bolts in the order shown in the illustration.

    2. A01J72SE02

      Connect the clamp and 2 connectors.

    3. Move the shift lever to L.

    4. Connect the transmission control cable.

  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  3. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

  4. ADJUST SHIFT LEVER POSITION

    A01J4K8E01

    1. Remove the nut and disconnect the control cable.

    2. Remove the clip and disconnect the control cable from the control cable bracket.

    3. A01J2YIE01

      Push the control shaft rearward as much as possible.

    4. Return the control shaft lever 2 notches to the N position.

    5. While holding the control shaft lever slightly toward the R position side, tighten the nut.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

  5. INSPECT SHIFT LEVER POSITION


    1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

    2. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D, and moves rearward after shifting to R.

      If the results are not as specified, inspect the park/neutral position switch and adjust the shift lever position.

  6. INSTALL CONSOLE BOX ASSEMBLY

    A01J4XBE01
    Text in Illustration
    *1 Screw
    *2 Bolt
    *3 Clip

    1. Install the console box with the 4 screws and 2 bolts.

    2. Install the 2 clips.

  7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. Attach the 12 claws to install the upper console panel.

      A01J6F0E01
      Text in Illustration
      *A for 2WD *B for 4WD

  8. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY


    1. Attach the 4 claws to install the parking brake hole cover.

  9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

    A01J4EQ

    1. Install the shift lever knob and twist it in the direction indicated by the arrow.