DIRECT CLUTCH DISASSEMBLY


  1. INSPECT PACK CLEARANCE OF DIRECT CLUTCH

    A01J7MTE01

    1. Place the direct clutch assembly onto the O/D support assembly.

    2. A01J5Y0E01

      Using SST and a dial indicator, measure the direct clutch pack clearance while applying and releasing compressed air (186 to 206 kPa (1.9 to 2.1 kgf/cm2, 27 to 30 psi)).

      SST
      09350-30020   ( 09350-06120 )
      Standard pack clearance
      0.40 to 0.70 mm (0.016 to 0.028 in.)

      If the pack clearance is not as specified, parts may have been assembled incorrectly. Check and reassemble again.

      If the pack clearance is still not as specified, select another flange.

      Tech Tips

      There are 8 different flange thicknesses.

      Standard flange thickness
      No. Specified Condition No. Specified Condition
      53 3.3 mm (0.130 in.) 57 3.7 mm (0.146 in.)
      54 3.4 mm (0.134 in.) 58 3.8 mm (0.150 in.)
      55 3.5 mm (0.138 in.) 60 4.0 mm (0.157 in.)
      56 3.6 mm (0.142 in.) 62 4.2 mm (0.165 in.)

  2. REMOVE DIRECT CLUTCH FLANGE

    A01J6HTE01

    1. Using a screwdriver, remove the snap ring from the direct clutch drum.

    2. Remove the flange, 5 plates and 5 discs.

  3. INSPECT DIRECT CLUTCH FLANGE

    A01J7NUE01

    1. Replace all discs if one of the following problems is present: 1) a disc, plate or flange is worn or burnt, 2) the lining of a disc is peeled off or discolored, or 3) grooves or printed numbers have even a little bit of damage.

      Note

      Before assembling new discs, soak them in ATF for at least 15 minutes.

  4. REMOVE DIRECT CLUTCH RETURN SPRING

  5. INSPECT DIRECT CLUTCH RETURN SPRING

    A01J5MSE02

    1. Using a vernier caliper, measure the free length of the spring together with the spring seat.

      Standard free length
      21.32 mm (0.839 in.)

      If the length is not as specified, replace the spring.

  6. REMOVE DIRECT CLUTCH PISTON

    A01J74NE01

    1. Place the direct clutch drum onto the overdrive support.

    2. Hold the direct clutch piston, and apply compressed air (196 kPa (2.0 kgf/cm2, 28.5 psi)) to the overdrive support to remove the direct clutch piston.

      Tech Tips

      Make sure the direct clutch piston is at a right angle to the drum before applying compressed air.

    3. Remove the direct clutch piston.

    4. A01J7G8E01

      Using a small screwdriver, remove the 2 O-rings from the piston.

  7. INSPECT DIRECT CLUTCH PISTON

    A01J512E01

    1. Check that the check ball is free by shaking the piston.

    2. Check that the valve does not have leaks by applying low-pressure compressed air.

  8. INSPECT DIRECT CLUTCH DRUM

    A01J5P6E01

    1. Using a dial indicator, measure the inside diameter of the clutch drum bush.

      Maximum inside diameter
      53.97 mm (2.1248 in.)

      If the inside diameter is greater than the maximum, replace the clutch drum.