AUTOMATIC TRANSMISSION SYSTEM L4 Position Switch Circuit

DESCRIPTION

The No. 1 transfer indicator switch (L4 position switch) detects the gear position of the transfer shift lever.

Moving the transfer shift lever to L4 turns the L4 position switch ON. Then the ECM cancels operation of the lock-up clutch.

WIRING DIAGRAM

A01J6ANE01

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH)


    1. A01J3GCE03

      Remove the transfer indicator switch.

    2. Measure the resistance of the switch when pushing the ball at the tip of the switch.

      Standard resistance
      Tester Connection Switch Condition Specified Condition
      1 - 2 Not pushed 10 kΩ or higher
      1 - 2 Pushed Below 1 Ω

    NG

    REPLACE NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH)

    OK

  2. CHECK WIRE HARNESS (NO. 1 TRANSFER INDICATOR SWITCH - ECM AND BODY GROUND)


    1. A01J58VE01

      Disconnect the T5 switch connector.

    2. Disconnect the E8 ECM connector.

    3. Measure the resistance of the wire harness side connectors.

      Standard resistance
      Tester Connection Specified Condition
      E8-11 (L4) - T5-1 (L4) Below 1 Ω
      T5-2 (L4) - Body ground Below 1 Ω
      E8-11 (L4) or T5-1 (L4) - Body ground 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS AND CONNECTOR

    OK

    PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE