ACCELERATOR PEDAL ROD INSTALLATION


  1. INSTALL ACCELERATOR PEDAL ROD

    Note

    This accelerator pedal does not require lubrication.

    Do not apply oil or other lubrication to the accelerator pedal rod.

    If applied, the accelerator pedal rod must be replaced.


    1. A01J408E01

      Install the accelerator pedal rod with the 2 bolts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

    2. Connect the accelerator pedal position sensor connector.

  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  3. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.