SFI SYSTEM (w/ Secondary Air Injection System), Diagnostic DTC:P060D

DTC Code DTC Name
P060D Internal Control Module Accelerator Pedal Position Performance

DESCRIPTION

The ECM monitors the input signals of the accelerator pedal position sensor No. 1. When the input signals and control signals deviate, a DTC is stored.

DTC No. DTC Detection Condition Trouble Area
P060D

Either condition is met (1 trip detection logic):


  • There is an ECM main CPU error.

  • There is an ECM sub CPU error.

 ECM

MONITOR STRATEGY

Required sensors/Components ECM
Frequency of operation Once per driving cycle

TYPICAL MALFUNCTION THRESHOLDS

Difference of main accelerator pedal position and sub accelerator pedal position 0.3 V or more

CONFIRMATION DRIVING PATTERN


  1. Turn the ignition switch off.

  2. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  3. Connect the cable to the negative (-) battery terminal.

  4. Turn the ignition switch to ON and wait for 16 seconds or more.

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK FOR DTC


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Clear the DTCs Click here.

    5. Turn the intelligent tester off.

    6. Turn the ignition switch off.

    7. Disconnect the intelligent tester.

    8. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    9. Connect the cable to the negative (-) battery terminal.

    10. Connect the intelligent tester to the DLC3.

    11. Turn the ignition switch to ON and turn the intelligent tester on.

    12. Wait 16 seconds or more.

    13. Enter the following menus: Powertrain / Engine and ECT / DTC.

    14. Check for DTCs.

      OK
      P060D is not output.

    NG

    REPLACE ECM Click here

    OK

    CHECK FOR INTERMITTENT PROBLEMS Click here