HOOD LOCK CONTROL CABLE ASSEMBLY REMOVAL

PROCEDURE


  1. REMOVE FRONT FENDER LINER LH (for LHD)

    Click here

  2. REMOVE FRONT FENDER LINER RH (for RHD)

    Tech Tips

    Use the same procedures as for the LH side Click here.

  3. REMOVE HOOD LOCK ASSEMBLY


    1. A004G0K

      Remove the 3 bolts and the hood lock.

    2. Disconnect the hood lock control cable.

    3. Disconnect the connector.

      Tech Tips

      If the hood lock assembly is equipped with engine hood courtesy switch, disconnect the connector.

  4. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A004EQV

      Disengage the 3 claws and remove the hood lock control lever.

    2. Disconnect the hood lock control cable.

  5. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)


    1. Using a screwdriver with its tip wrapped in protective tape, disconnect the clamps shown in the illustration.

      A004EAPE01
      Text in Illustration
      *1 Hood Lock Control Cable *2 Clamp
      *3 Grommet - -

    2. Pull the hood lock control cable from the engine compartment and remove it.

  6. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)


    1. Using a screwdriver with its tip wrapped in protective tape, disconnect the clamps shown in the illustration.

      A004E69E01
      Text in Illustration
      *1 Hood Lock Control Cable *2 Clamp
      *3 Grommet - -

    2. Pull the hood lock control cable from the engine compartment and remove it.