ROOF WINDOW FIX GLASS REMOVAL

PROCEDURE


  1. REMOVE SUNSHADE TRIM SUB-ASSEMBLY

    Click here

  2. REMOVE ROOF DRIP SIDE FINISH MOULDING LH

    Click here

  3. REMOVE ROOF DRIP SIDE FINISH MOULDING RH

    Tech Tips

    Use the same procedure as for the LH side.

  4. REMOVE NO. 1 ROOF WINDOW GLASS SUB-ASSEMBLY

    Note

    To prevent the roof window glass from dropping when performing this operation, be sure to hold the roof window glass using suction cups.


    1. A01V1PEE02
      Text in Illustration
      *1 Adhesive Tape
      *2 Windshield Glass
      *3 Windshield Glass Outside Moulding
      *4 No. 1 Roof Window Glass Sub-assembly

      Turn the lip of the windshield outside moulding and hold it with adhesive tape.

    2. A01V05ME01
      Text in Illustration
      *1 Protective Tape

      Apply protective tape to the installation position of the roof window glass on the vehicle body.

    3. Pass a piano wire between the vehicle body and glass from the interior, as shown in the illustration.

      A01V0NOE01
      Text in Illustration
      *1 Piano Wire - -

    4. Tie both wire ends to wooden blocks or similar objects.

    5. Cut off the adhesive by pulling the piano wire around the roof window glass.

      Note

      When separating the roof window glass, take care not to damage the paint or the interior and exterior ornaments.

    6. A01V0CU

      Using suction cups, disengage the 2 pins and remove the roof window glass.

      Note

      Be careful not to drop the roof window glass.