POWER WINDOW CONTROL SYSTEM OPERATION CHECK


  1. CHECK WINDOW LOCK SWITCH

    Tech Tips

    Before performing the window lock switch operation check, make sure that the window lock switch is off (the switch is not pushed in).


    1. Check that the front passenger and rear windows* cannot be operated from each power window regulator switch assembly (front passenger side, rear LH side* or rear RH side*) when the window lock switch of the power window regulator master switch assembly is pushed in.


      • *: w/ Rear Power Window

    2. Check that the front passenger and rear windows* can be operated from each power window regulator switch assembly (front passenger side, rear LH side* or rear RH side*) when the window lock switch of the power window regulator master switch assembly is pushed in again.


      • *: w/ Rear Power Window

    3. CHECK MANUAL UP / DOWN FUNCTION


      1. Check that the driver side power window operates as follows:

    4. Check that the front passenger side window and rear power windows* operate as follows:

      5. *: w/ Rear Power Window

    5. CHECK AUTO UP / DOWN FUNCTION


      1. Check that the driver side power window operates as follows:

    6. CHECK REMOTE MANUAL UP / DOWN FUNCTION


      1. Check that the front passenger side window and rear power windows* operate as follows:


      • *: w/ Rear Power Window

    7. CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH IS TURNED OFF


      1. Check that all the power windows can be operated with the power window regulator master switch assembly and power window regulator switch assembly (front passenger side, rear LH side* or rear RH side*) after the ignition switch is turned off.


        • *: w/ Rear Power Window

      2. Check that the key-off operation function does not operate after the driver door or front passenger door are opened.

      3. Check that all the power windows cannot be operated after more than approximately 45 seconds have elapsed since the ignition switch was turned off.

    8. CHECK JAM PROTECTION FUNCTION (DRIVER DOOR POWER WINDOW)


      1. Check the basic function.

        CAUTION:

        Do not put your fingers between the door frame and door glass to check the jam protection function. Also, prevent any part of your body from being caught during inspection.

        Tech Tips

        The jam protection function is operative during both the auto up and manual up operations while the engine is running or the ignition switch is ON (IG), and also within 45 seconds after the ignition switch is turned off.


        1. Fully open the window.

        2. A01V09SE01
      9. Text in Illustration
      *1 Thick Book
      *2 Cloth

Set a thick book wrapped with a piece of cloth near the window fully closed position.

  • Operate the auto up or manual up function to check that the power window goes down after the book is caught between the window and door frame, and stops when the opening reaches approximately 200 mm (7.87 in.).

    Tech Tips

    The power window moves down approximately 125 mm (4.93 in.). However, when the opening does not reach 200 mm (7.87 in.), the power window continues to go down until the opening reaches 200 mm (7.87 in.) or until approximately 5 seconds elapse.

  • While the power window is moving down, check that the door glass cannot be raised when the power window switch is used.

  • CHECK POWER WINDOW SWITCH LED ILLUMINATION


    1. Check the LED illumination (power window regulator master switch assembly).


      1. Check that the LED located on the power window regulator master switch assembly illuminates when the ignition switch is turned to ON (IG).