POWER WINDOW CONTROL SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use the following procedure to troubleshoot the power window control system.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. CUSTOMER PROBLEM ANALYSIS


    • In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

    • Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

    • The following 5 items are important points in the problem analysis:

      What Vehicle model, system name
      When Date, time, occurrence frequency
      Where Road conditions
      Under what conditions? Driving conditions, weather conditions
      How did it happen? Problem symptoms
    Result
    Proceed to
    NEXT

    NEXT

  3. PRE - CHECK


    1. Measure the auxiliary battery voltage with the ignition switch off.

      Standard voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

    2. Check the fuses and relays.

    3. Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK LIN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the LIN communication system is functioning.

      Result
      Result Proceed to
      LIN DTC is not output A
      LIN DTC is output B

    B

    GO TO LIN COMMUNICATION SYSTEM Click here

    A

  5. CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output.

      Click here

    2. Clear the DTCs.

    3. Recheck for DTCs.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    A

  6. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

    B

    GO TO STEP 8 Click here

    A

  7. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Operation Check.

      Click here

    2. Data List / Active Test.

      Click here

    3. Terminals of ECU.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  8. REPAIR OR REPLACE

    Result
    Result Proceed to
    Door window regulator assembly replaced or removed/installed A
    Door window regulator assembly not replaced or removed/installed B

    B

    GO TO STEP 10 Click here

    A

  9. INITIALIZE FRONT DOOR WINDOW REGULATOR ASSEMBLY


    1. If a power window regulator master switch LED is blinking, initialize the front door window regulator assembly.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  10. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END