POWER WINDOW CONTROL SYSTEM, Diagnostic DTC:B2311

DTC Code DTC Name
B2311 Power Window Motor Malfunction

DESCRIPTION

The door window regulator assembly is operated by the power window regulator master switch assembly. The front door window regulator assembly (driver side) has motor, regulator and ECU functions.

This DTC is output when the front door window regulator assembly (driver side) has a malfunction, or the ECU built into the front door window regulator assembly (driver side) determines that the fully closed window position has deviated approximately 20 mm (0.787 in.) or more from the normal position.

DTC No. DTC Detection Condition Trouble Area
B2311

  • Either condition is met:


    1. Front door window regulator assembly (driver side) malfunctions

    2. When ECU in front door window regulator assembly (driver side) determines that fully closed window position has deviated approximately 20 mm (0.787 in.) or more from normal position

  • Front door window regulator assembly (driver side)

  • Incorrect installation of power window components

CAUTION / NOTICE / HINT

Note


  • When the front door window regulator assembly (driver side) is reinstalled or replaced, the power window control system must be initialized.

  • After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operations at least 5 times:


    1. Close the power window by fully pulling up the power window regulator master switch assembly and holding it in the auto up position.

    2. Open the power window by fully pushing down the power window regulator master switch assembly.

PROCEDURE


  1. PERFORM ACTIVE TEST USING GTS


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / D-Door Motor / Active Test.

    5. According to the display on the GTS, perform the Active Test.

      CAUTION:

      Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function will not operate.

      D-Door Motor
      Tester Display Test Part Control Range Diagnostic Note
      Power Window Power window OFF / DOWN / UP -
      OK
      Front door window regulator assembly (driver side) operates.

    NG

    REPLACE FRONT DOOR WINDOW REGULATOR ASSEMBLY (DRIVER SIDE) Click here

    OK

  2. PERFORM INITIALIZATION (DRIVER SIDE)


    1. Initialize the front door window regulator assembly (driver side) Click here.

    2. Check that front door window regulator assembly (driver side) operates normally by opening and closing the window Click here.

      OK
      Front door window regulator assembly (driver side) operates normally.

    NG

    REPLACE FRONT DOOR WINDOW REGULATOR ASSEMBLY (DRIVER SIDE) Click here

    OK

  3. CHECK WHETHER PARTS HAVE BEEN INSTALLED CORRECTLY


    1. Check that the power window components are installed correctly.

      OK
      Driver side power window components are installed correctly.

      Tech Tips

      When the power window components are installed correctly, the problem has occurred because, the power window components are installed improperly or the motor is overheated.


    OK

    END

    NG

    INSTALL PARTS CORRECTLY