AIR CONDITIONING PRESSURE SENSOR ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT AIR CONDITIONER PRESSURE SENSOR


    1. A01V1LAE01
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Air Conditioner Pressure Sensor)

      Check the wire harness.


      1. Disconnect the connector of the air conditioner pressure sensor.

      2. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        A23-1 (-) - Body ground Always Below 1 Ω

      3. Turn the ignition switch to ON.

      4. Measure the voltage according to the value(s) in the table below.

        Standard Voltage
        Tester Connection Switch Condition Specified Condition
        A23-3 (+) - Body ground Ignition switch ON 4.75 to 5.25 V
    2. A01UY0RE01
      Text in Illustration
      *a

      Component with harness connected

      (Air Conditioning Amplifier Assembly)

      Check the air conditioner pressure sensor.


      1. Set the manifold gauge.

      2. Connect the connector to the air conditioner pressure sensor.

      3. Warm up the engine.

      4. A/C switch on.

      5. Measure the voltage according to the value(s) in the table below.

        Tech Tips

        Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.

        Standard Voltage
        Tester Connection Refrigerant Pressure Specified Condition
        F42-9 (PRE) - F42-13 (SG-2)

        0.196 to 3.14 MPa

        (2.0 to 32 kgf/cm2, 28 to 455 psi)

        		 0.66 to 4.88 V