CONDENSER INSTALLATION

PROCEDURE

1. INSTALL COOLER CONDENSER ASSEMBLY

   
   

   1. Engage the 2 guides and install the cooler condenser into the vehicle.

      Note

      Do not damage the condenser or radiator when installing the condenser.

      Tech Tips

      If a new cooler condenser is installed, add compressor oil to the condenser as follows.

      Capacity
      Add 40 cc (1.35 fl. oz.)

      Compressor oil
      ND-OIL11 or equivalent.

2. INSTALL NO. 2 FAN SHROUD

   
   

   1. Engage the 2 claws and install the fan shroud.

   2. Install the 2 bolts.

      Torque:

      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

3. INSTALL NO. 2 RADIATOR SIDE AIR SEAL

   Click here

4. INSTALL NO. 1 RADIATOR SIDE AIR SEAL

   Click here

5. INSTALL RADIATOR UPPER SUPPORT SUB-ASSEMBLY

   
   

   1. Install the 4 bolts and the radiator upper support.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

   2. Engage the 2 clamps and install the hood lock control cable.

   3. Engage the 2 clamps and install the wire harness.

   4. Connect the connector.

6. CONNECT LIQUID TUBE SUB-ASSEMBLY A

   
   

   1. Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser.

   2. Apply sufficient compressor oil to a new O-ring and the fitting surface of the tube joint.

      Compressor oil
      ND-OIL11 or equivalent.

   3. Install the O-ring onto the liquid tube.

   4. Install the liquid tube onto the cooler condenser with the bolt.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

7. CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

   
   

   1. Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser.

   2. Apply sufficient compressor oil to a new O-ring and the fitting surface of the hose joint.

      Compressor oil
      ND-OIL11 or equivalent.

   3. Install the O-ring onto the discharge hose.

   4. Install the discharge hose onto the cooler condenser with the bolt.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

8. INSTALL FRONT AIRBAG SENSOR

   Click here

9. INSTALL RADIATOR SUPPORT OPENING COVER

   Click here

10. INSTALL HEADLIGHT ASSEMBLY LH

    Click here

11. INSTALL HEADLIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

12. CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT

    Click here

13. WARM UP COMPRESSOR

    Click here

14. INSPECT FOR REFRIGERANT LEAK

    Click here

15. PREPARE VEHICLE FOR HEADLIGHT AIMING ADJUSTMENT

    Click here

16. PREPARE FOR HEADLIGHT AIMING

    Click here

17. INSPECT HEADLIGHT AIMING

    Click here

18. ADJUST HEADLIGHT AIMING

    Click here