REAR SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

PROCEDURE


  1. INSTALL SEAT BELT HOLE SEAL


    1. Engage the 2 claws to install the seat belt hole seal.

  2. INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY


    1. A01V1WYE01
      Text in Illustration
      *a Lock
      *b Unlock

      Check the angle of inclination required to lock the retractor.


      1. Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.

        Note

        Do not disassemble the retractor.

        If the operation is not as specified, replace the rear seat 3 point type outer belt assembly.

    2. Engage the 2 hooks to install the rear seat 3 point type outer belt assembly.

    3. Install the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    4. Install the shoulder anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    5. Engage the 2 claws to install the floor anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    6. Check that the ELR locks.

      Note

      Perform the check with the rear seat 3 point type outer belt assembly installed.


      1. With the belt installed, check that the belt locks when it is pulled out quickly.

        Note

        If the operation is not as specified, replace the rear seat 3 point type outer belt.

    7. Remove the bolt.

    8. Disengage the 2 claws to remove the floor anchor.

  3. INSTALL ROOF SIDE INNER GARNISH

    Click here

  4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)

    Click here

  5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)

    Click here

  6. CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

    Click here

  7. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

    Click here

  8. INSTALL REAR DOOR SCUFF PLATE

    Click here

  9. INSTALL JACK HANDLE (for RH Side)

  10. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side)

    Click here

  11. INSTALL REAR FLOOR FINISH PLATE

    Click here

  12. INSTALL SPARE WHEEL COVER (w/ Cover)

    Click here

  13. INSTALL DECK BOARD ASSEMBLY (w/ Deck Board)

    Click here

  14. INSTALL FRONT FLOOR COVER RH (for RH Side)

    Install the front floor cover RH (for Front Floor Cover Type A). Click here

    Install the front floor cover RH (for Front Floor Cover Type B). Click here

  15. INSTALL FRONT FLOOR COVER LH (for LH Side)

    Install the front floor cover LH (for Front Floor Cover Type A). Click here

    Install the front floor cover LH (for Front Floor Cover Type B). Click here

  16. INSTALL CENTER FRONT FLOOR COVER (for Front Floor Cover Type B)

    Click here

  17. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)

    Click here

  18. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)

    Click here