FRONT SEAT CUSHION HEATER INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:


  • Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Note

Always use E10 "TORX" socket wrench when removing the front seat.

Tech Tips

The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.

PROCEDURE


  1. INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY


    1. Using a tacker, install the front seat cushion heater assembly to the end of the seat cover with 8 new tag pins.

  2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER

    Click here

  3. INSTALL SEAT CUSHION COVER WITH PAD

    Click here

  4. INSTALL FRONT SEAT CUSHION INNER SHIELD LH

    Click here

  5. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)

    Click here

  6. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)

    Click here

  7. INSTALL FRONT SEAT CUSHION COVER (for LHD)

    Click here

  8. INSTALL FRONT SEAT CUSHION SHIELD LH

    Click here

  9. INSTALL VERTICAL ADJUSTING HANDLE LH (w/ Vertical Adjuster)

    Click here

  10. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  11. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  12. INSTALL SEAT TRACK COVER OUTER RH

    Click here

  13. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  14. INSTALL FRONT FLOOR COVER RH (for Front Floor Cover Type A)

    Click here

  15. INSTALL FRONT FLOOR COVER RH (for Front Floor Cover Type B)

    Click here

  16. INSTALL CENTER FRONT FLOOR COVER (for Front Floor Cover Type B)

    Click here

  17. INSPECT SRS WARNING LIGHT

    Click here