CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.
Wear protective gloves. Sharp areas on the parts may injure your hands.
Note
Always use E10 "TORX" socket wrench when removing the front seat.
Tech Tips
The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.
PROCEDURE
INSTALL FRONT SEATBACK HEATER ASSEMBLY
Using a tacker, install the front seatback heater assembly to the end of the seat cover with 6 new tag pins.
INSTALL SEPARATE TYPE FRONT SEATBACK COVER
INSTALL SEATBACK COVER WITH PAD
INSTALL SEAT ARMREST ASSEMBLY (w/ Armrest)
INSTALL SEAT ARMREST HOLE COVER (w/ Armrest)
INSTALL FRONT SEAT CUSHION SHIELD INNER LH
INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)
INSTALL FRONT SEAT CUSHION COVER (for LHD)
INSTALL FRONT SEAT CUSHION SHIELD LH
INSTALL VERTICAL ADJUSTING HANDLE LH (w/ Vertical Adjuster)
INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
INSTALL FRONT SEAT HEADREST ASSEMBLY
INSTALL FRONT SEAT ASSEMBLY LH
INSTALL SEAT TRACK COVER OUTER LH
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL FRONT FLOOR COVER RH (for Front Floor Cover Type A)
INSTALL FRONT FLOOR COVER RH (for Front Floor Cover Type B)
INSTALL CENTER FRONT FLOOR COVER (for Front Floor Cover Type B)
INSPECT SRS WARNING LIGHT