FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type A)

    Click here

  3. REMOVE FRONT FLOOR COVER LH (for Front Floor Cover Type A)

    Click here

  4. REMOVE CENTER FRONT FLOOR COVER (for Front Floor Cover Type B)

    Click here

  5. REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type B)

    Click here

  6. REMOVE FRONT FLOOR COVER LH (for Front Floor Cover Type B)

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  9. REMOVE REAR DOOR SCUFF PLATE

    Click here

  10. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the front door opening trim weatherstrip.

  11. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the rear door opening trim weatherstrip.

  12. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A004G61

      Disengage the 3 claws and remove the lap belt outer anchor cover.

    2. A004G9I

      Remove the bolt and disconnect the floor anchor part of the front seat outer belt assembly.

  13. REMOVE CENTER PILLAR LOWER GARNISH

    Click here

  14. REMOVE CENTER PILLAR UPPER GARNISH

    Click here

  15. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A004ENP

      Remove the bolt and the shoulder anchor part of the front seat outer belt assembly.

    2. A004GG4C01
      *a Protective Tape
      *b Locking Button

      Using a screwdriver with its tip wrapped in protective tape, release the locking button.

    3. Disconnect the pretensioner connector.

    4. A004FL4

      Remove the 2 bolts.

    5. Disengage the 2 hooks and remove the front seat outer belt assembly.