AIRBAG CUT-OFF SWITCH REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type A)

    Click here

  3. REMOVE CENTER FRONT FLOOR COVER (for Front Floor Cover Type B)

    Click here

  4. REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type B)

    Click here

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  7. REMOVE AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY


    1. Disconnect the airbag cut off switch cylinder sub-assembly connector.

    2. A004GDC

      Disengage the 2 claws to remove the airbag cut off switch cylinder sub-assembly.