CENTER AIRBAG SENSOR ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type A)

    Click here

  3. REMOVE CENTER FRONT FLOOR COVER (for Front Floor Cover Type B)

    Click here

  4. REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type B)

    Click here

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE REAR CONSOLE BOX

    Click here

  7. REMOVE AIRBAG SENSOR ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A004EAME01
      Text Illustration
      *1 Lever

      Pull the lever down and disconnect the connector holder.

      Note

      When disconnecting the airbag connector, take care not to damage the airbag wire harness.

    4. A004F3M

      Remove the 3 bolts and the airbag sensor assembly.