FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. INSTALL NO. 2 INSTRUMENT PANEL WIRE

    A01V00ME01
    Text in illustration
    *1 Locking Button

    1. Connect the airbag connector to the instrument panel passenger airbag assembly.

      Note


      • Do not damage the airbag wire harness when connecting the airbag connector.

      • Securely lock the locking button.

  2. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A01UY8DE02

      Engage the 3 hooks B.

    4. Engage the 3 hooks A to preliminary install the instrument panel passenger airbag assembly.

    5. A01UZ8V

      Install the 2 screws

    6. Engage the 2 hooks to install the upper instrument pane sub-assembly.

  3. INSTALL NO. 2 HEATER TO REGISTER DUCT

    Click here

  4. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSTALL FRONT FLOOR COVER RH (for Front Floor Cover Type A)

    Click here

  7. INSTALL FRONT FLOOR COVER RH (for Front Floor Cover Type B)

    Click here

  8. INSTALL CENTER FRONT FLOOR COVER (for Front Floor Cover Type B)

    Click here

  9. INSPECT SRS WARNING LIGHT

    Click here