FRONT PASSENGER AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  3. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  4. REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

    Click here

  5. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

    A004EHY

    1. Remove the 2 screws.

    2. Disengage the 2 hooks.

    3. A004FCXE02

      Disengage the 3 hooks A.

    4. Disengage the 3 hooks B to remove the instrument panel passenger airbag assembly as shown in the illustration.

  6. REMOVE NO. 2 INSTRUMENT PANEL WIRE


    1. A004F9KE01
      Text in illustration
      *1 Protective Tape
      *2 Locking Button

      Using a screwdriver with its tip wrapped with protective tape, release the locking button.

    2. Using a screwdriver with its tip wrapped with protective tape, disconnect the airbag connector and remove the No. 2 instrument panel wire.