SIDE AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

Tech Tips

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

PROCEDURE


  1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Insert the pin (stopper) into the body hole to install the side airbag sensor assembly to the vehicle with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the side airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the pin (stopper) is securely inserted into the body hole.

      • Tighten the bolt while holding the side airbag sensor assembly because the side airbag sensor assembly pin (stopper) is easily damaged.

    4. Connect the connector to the side airbag sensor assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.


      1. Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original position and a click sound can be heard).

        A01UYH7E06
        Text in Illustration
        *1 Outer Connector Locking Sleeve - -
        *a Slide - -

        Tech Tips

        When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting, as it may result in an insecure fit.

    5. Check that there is no looseness in the installation parts of the side airbag sensor assembly.

  2. INSTALL CENTER PILLAR LOWER GARNISH RH

    Click here

  3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH

    Click here

  4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

    Click here

  5. INSTALL REAR DOOR SCUFF PLATE RH

    Click here

  6. INSTALL FRONT DOOR SCUFF PLATE RH

    Click here

  7. INSTALL FRONT FLOOR COVER RH (for Front Floor Cover Type A)

    Click here

  8. INSTALL FRONT FLOOR COVER RH (for Front Floor Cover Type B)

    Click here

  9. INSTALL FRONT FLOOR COVER LH (for LH Side)

    Install the front floor cover LH (for Front Floor Cover Type A). Click here

    Install the front floor cover LH (for Front Floor Cover Type B). Click here

  10. INSTALL CENTER FRONT FLOOR COVER (for Front Floor Cover Type B)

    Click here

  11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  12. INSPECT SRS WARNING LIGHT

    Click here