SPIRAL CABLE REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. TURN FRONT WHEELS FACING STRAIGHT AHEAD

2. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

3. REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type A)

   Click here

4. REMOVE CENTER FRONT FLOOR COVER (for Front Floor Cover Type B)

   Click here

5. REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type B)

   Click here

6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

7. REMOVE STEERING PAD

   Click here

8. REMOVE STEERING WHEEL ASSEMBLY

   Click here

9. REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)

   Click here

10. REMOVE LOWER STEERING COLUMN COVER

    Click here

11. REMOVE UPPER STEERING COLUMN COVER

    Click here

12. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    

    Text in illustration

    *1

    Slider

    
    

    1. Disconnect the horn connector from the spiral cable with sensor sub-assembly.

    2. Slide the slider and disconnect the airbag connector from the spiral cable with sensor sub-assembly.

       Note

       When disconnecting the airbag connector, take care not to damage the airbag wire harness.

    3. Disconnect the steering sensor connector from the spiral cable with sensor sub-assembly.

    4. 

       Disengage the 3 claws and remove the spiral cable with sensor sub-assembly.

       Note

       
       

       • Do not replace the spiral cable with sensor sub-assembly when the ignition switch is ON and the auxiliary battery cable is connected.

       • Do not rotate the spiral cable with sensor sub-assembly when the ignition switch is ON and the auxiliary battery cable is connected.

       • Make sure the steering wheel is installed and centered before rotating the steering angle sensor when performing steering angle sensor operation inspections (inspecting for abnormal noise, diagnosis inspections, etc.).

       • Do not remove the steering sensor from the spiral cable with sensor sub-assembly.

       • If there is a malfunction in the steering sensor, replace the spiral cable with sensor sub-assembly with steering sensor.