ENGINE IMMOBILISER SYSTEM(w/o Power Switch) HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use these procedures to troubleshoot the engine immobiliser system.

  • *: Use the GTS.

  • If the ignition switch cannot be turned to ON, communication with the GTS can be performed by connecting the GTS to the vehicle and turning a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and vehicle begins.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT AUXILIARY BATTERY VOLTAGE

    Standard Voltage
    11 to 14 V (Ignition switch off)

    If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.

    Tech Tips

    A simple method to determine whether the auxiliary battery is depleted is to operate the horn.

    Result
    Proceed to
    NEXT

    NEXT

  3. CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output.

      Click here

    2. Based on the DTCs output above, proceed to each diagnostic procedure.

      Result
      Result Proceed to
      DTC is not output A
      Hybrid control system DTC is output B
      Engine immobiliser system DTC is output C

    B

    GO TO HYBRID CONTROL SYSTEM Click here

    C

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    A

  4. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

    B

    GO TO STEP 6 Click here

    A

  5. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Data List / Active Test.

      Click here

    2. Terminals of ECU.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  6. REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  7. CHECK FOR DTC*


    1. Clear the DTCs.

      Click here

    2. Check for DTCs.

      Click here

      Tech Tips

      Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure.

      Click here

      Result
      Result Proceed to
      DTC is not output A
      Engine immobiliser system DTC is output B

    A

    END

    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here