REAR DOOR LOCK INSTALLATION

PROCEDURE

APPLY BODY GREASE
INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY
1. Install the rear door inside locking cable to the rear door lock.
2. Engage the 4 claws.
INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
1. Install the rear door lock remote control cable to the rear door lock.
2. Engage the 2 claws.
INSTALL REAR DOOR LOCK ASSEMBLY
Note
- If reusing the rear door lock assembly that has been removed, replace the connector seal with a new door lock wire harness seal.
- Make sure that no grease or dirt adheres to the door lock wire harness seal surface.
- Reusing the door lock wire harness seal or using a damaged door lock wire harness seal may cause water intrusion to the connection. This may result in a malfunction of the rear door lock.
1. Install a new door lock wire harness seal to the rear door lock.
2. Apply MP grease to the sliding parts of the rear door lock.
3. Text in Illustration
  
  *1 Release Plate
  
  Slide Direction
  
  Insert the rear door lock to the release plate.
  
  Tech Tips
  
  Make sure that the release plate is securely connected to the rear door lock.
4. Using a T30 "TORX" socket wrench, install the rear door lock assembly with the 3 screws.
  
  Torque:
  
  5.0 N*m { 51 kgf*cm, 44 in.*lbf }
5. Connect the connector.
INSTALL REAR DOOR GLASS RUN

Click here
INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Click here
INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Click here
INSTALL REAR DOOR SERVICE HOLE COVER

Click here
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Click here
INSTALL REAR DOOR ARMREST BASE UPPER PANEL (w/ Power Window)

Click here
INSTALL REAR DOOR ARMREST BASE UPPER PANEL (w/o Power Window)

Click here
INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Click here
INSTALL REAR DOOR FRAME GARNISH

Click here

Text in Illustration
*1	Release Plate
	Slide Direction