KEY REMINDER WARNING SYSTEM(w/o Power Switch) DATA LIST / ACTIVE TEST


  1. READ DATA LIST

    Note

    In the table below, the values listed under Normal Condition are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time


    1. Turn the ignition switch off.

    2. Connect the GTS to the DLC3

    3. Turn the ignition switch to ON (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Main Body / Data List.

    6. According to the display on the GTS, read the Data List.

      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Key Unlock Warning SW Unlock warning switch / OFF or ON

      OFF: Ignition key is not inserted

      ON: Ignition key is inserted

      		 -
      ACC SW Ignition switch ACC signal / OFF or ON

      OFF: Ignition switch off

      ON: Ignition switch ACC

      		 -
      IG SW Ignition switch on signal / OFF or ON

      OFF: Ignition switch off

      ON: Ignition switch ON (IG)

      		 -
      FR Door Courtesy SW Front RH door courtesy light switch signal / OFF or ON

      OFF: Front RH door closed

      ON: Front RH door opened

      		 -
      FL Door Courtesy SW Front LH door courtesy light switch signal / OFF or ON

      OFF: Front LH door closed

      ON: Front LH door opened

      		 -