CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for both the RH and LH sides.
The procedure described below is for the RH side.
PROCEDURE
REMOVE FRONT ARMREST BASE UPPER PANEL
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
REMOVE FRONT DOOR SERVICE HOLE COVER
REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
REMOVE FRONT DOOR GLASS RUN
REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
REMOVE FRONT DOOR OUTSIDE HANDLE COVER (w/ Lock Cylinder)
| *1 | Hole Plug |
Remove the hole plug.
Using a T30 "TORX" socket wrench, loosen the screw to remove the front door outside handle cover with lock cylinder.
REMOVE FRONT DOOR LOCK ASSEMBLY
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 screws.
| *1 | Front Door Lock Open Rod |
Remove the front door lock assembly from the front door lock open rod as shown in the illustration.
Remove the door lock wire harness seal from the front door lock assembly.
REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Double Locking System)
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the 7 claws to open the cover.
Disengage the guide to remove the front door lock remote control cable assembly from the front door lock assembly.
REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Double Locking System)
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws to open the cover.
Disengage the guide to remove the front door lock remote control cable assembly from the front door lock assembly.
REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Double Locking System)
Disengage the guide to remove the front door inside locking cable assembly from the front door lock assembly.
REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Double Locking System)
Disengage the guide to remove the front door inside locking cable assembly from the front door lock assembly.