POWER DOOR LOCK CONTROL SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON (IG).

    3. Turn the GTS on.

    4. Enter the following menus:

      Body Electrical / (desired system) / Data List.

    5. According to the display on the GTS, read the Data List.

      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Key Unlock Warning SW*1 Unlock warning switch signal / OFF or ON

      OFF: No key is in ignition key cylinder

      ON: Key is in ignition key cylinder

      		 -
      ACC SW Ignition switch status / OFF or ON

      OFF: Ignition switch off

      ON: Ignition switch ACC

      		 -
      IG SW Ignition switch status / OFF or ON

      OFF: Ignition switch off

      ON: Ignition switch to ON (IG)

      		 -
      RR Door Courtesy SW Rear door courtesy light switch LH and RH signal / OFF or ON

      OFF: Rear door LH and RH closed

      ON: Rear door LH or RH opened

      		 -
      RL Door Courtesy SW Rear door courtesy light switch LH and RH signal / OFF or ON

      OFF: Rear door LH and RH closed

      ON: Rear door LH or RH opened

      		 -
      Back Door Courtesy SW Back door courtesy switch signal / OFF or ON

      OFF: Back door closed

      ON: Back door opened

      		 -
      Back Door Open Back door open status / Prohibit or Permit

      Prohibit: Back door locked

      Permit: Back door unlocked

      		 -
      Door Lock SW-Lock Door manual lock switch signal / OFF or ON

      OFF: Door control switch (for front driver door side) is turned to unlock position

      ON: Door control switch (for front driver door side) is turned to lock position

      		 -
      Door Lock SW-Unlock Door manual unlock switch signal / OFF or ON

      OFF: Door control switch (for front driver door side) is turned to lock position

      ON: Door control switch (for front driver door side) is turned to unlock position

      		 -
      Door Key SW-Lock Door key lock and unlock switch signal/ OFF or ON

      OFF: Driver side door key cylinder not turned

      ON: Driver side door key cylinder turned to lock position

      		 -
      Door Key SW-Unlock Door key lock and unlock switch signal/ OFF or ON

      OFF: Driver side door key cylinder not turned

      ON: Driver side door key cylinder turned to unlock position

      		 -
      FR Door Lock Pos Front door unlock detection switch RH signal / LOCK or UNLOCK

      LOCK: Front RH locked

      UNLOCK: Front RH door unlocked

      		 -
      FR Door Courtesy SW Front RH door courtesy light switch signal / OFF or ON

      OFF: Front RH door closed

      ON: Front RH door opened

      		 -
      FL Door Lock Pos Front door unlock detection switch LH signal / LOCK or UNLOCK

      LOCK: Front LH side door locked

      UNLOCK: Front LH side door unlocked

      		 -
      FL Door Courtesy SW Front LH door courtesy light switch signal / OFF or ON

      OFF: Front LH door closed

      ON: Front LH door opened

      		 -
      Back Door Open Handle SW Back door opener switch signal / OFF or ON

      OFF: Back door opener switch not pushed

      ON: Back door opener switch pushed

      		 -
      RR-Door Lock Pos SW Rear door unlock detection switch LH and RH signal / OFF or ON

      OFF: Rear door LH and RH locked

      ON: Rear door LH or RH unlocked

      		 -
      RL-Door Lock Pos SW Rear door unlock detection switch LH and RH signal / OFF or ON

      OFF: Rear door LH and RH locked

      ON: Rear door LH or RH unlocked

      		 -
      Communication Double Locking*2 Connection status between double door lock ECU and main body ECU / STOP or OK

      STOP: No connection

      OK: Connection

      		 -

      • *1: w/o Power Switch

      • *2: w/ Double Locking System

      Entry & Start
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Tr/B-Door Lock SW Back door opener switch assembly (lock switch) / OFF or ON

      OFF: Back door opener switch (lock switch) not pushed

      ON: Back door opener switch assembly (lock switch) pushed

      		 -
      Tr/B-Door Unlock SW Back door opener switch assembly (unlock switch) / OFF or ON

      OFF: Back door opener switch (unlock switch) not pushed

      ON: Back door opener switch assembly (unlock switch) pushed

      		 -

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON (IG).

    3. Turn the GTS on.

    4. Enter the following menus:

      Body Electrical / Main Body / Active Test.

    5. According to the display on the GTS, perform the Active Test.

      Main Body
      Tester Display Test Part Control Range Diagnostic Note
      Door Lock Door lock motor OFF / Unlock / Lock -
      Trunk and Back-Door Open Back door lock motor OFF / ON -