CAN COMMUNICATION SYSTEM(w/ Toyota Safety Sense) Open in One Side of Bus 2 Branch Line

DESCRIPTION

When the CAN bus main lines are normal (no open, short to ground, short to +B or short between lines) and there is an ECU or sensor on the "Communication Bus Check" screen that is indicated as not communicating or whose connection status on the "Communication Bus Check" screen changes intermittently, an open in one of the wires of a CAN bus branch line is suspected.

Tech Tips

If there is an ECU or sensor whose connection status changes intermittently while checking the "Communication Bus Check" screen, there may be an open circuit in one of the wires of a branch line of an ECU or sensor in the bus. If an open occurs in one of the wires of a CAN branch line, it may interfere with the communication of other ECUs or sensors resulting in an incorrect state being displayed.

Symptom Trouble Area
There is an ECU or sensor that is indicated as not communicating on the "Communication Bus Check" screen or whose connection status on the "Communication Bus Check" screen changes intermittently.

One side of CAN branch line is open, or output signals are incomplete.


  • ECM

  • Hybrid vehicle control ECU

  • Pre-crash safety city sensor

  • Brake booster with master cylinder assembly (Skid control ECU)

  • Main body ECU (Multiplex network body ECU)

  • Air conditioning amplifier assembly

  • Power steering ECU assembly

  • Smart key ECU assembly (Certification ECU)*1

  • Airbag sensor assembly

  • Spiral cable with sensor sub-assembly (Steering sensor)

  • Combination meter assembly

CAUTION / NOTICE / HINT

Note


  • Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output Click here.

  • After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.

  • DTC check procedure: Turn the ignition switch to ON (IG), turn the cruise control system on using the cruise control main switch (ON/OFF switch), wait at least 60 seconds, and then drive the vehicle at a speed of 20 km/h (12 mph) or more.

  • After the repair, perform Communication Bus Check and check that all the ECUs and sensors connected to the CAN communication system are displayed as normal Click here.

Tech Tips

Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

PROCEDURE


  1. CHECK FOR OPEN IN ONE SIDE OF BUS 2 BRANCH LINE


    1. Based on the vehicle equipment and specifications, confirm the systems that use CAN communication Click here.

    2. Using the GTS, select and perform the communication bus check Click here.

    3. Observe the screen for approximately 2 minutes to check the ECUs and sensors that are not displayed on the screen and also those that repeatedly appear and disappear from the screen.

    4. Check the applicable communication stop mode for the ECU or sensor that is not displayed on the screen.


    NEXT

    GO TO CORRESPONDING COMMUNICATION STOP MODE Click here