REAR VIEW MONITOR SYSTEM Image from Camera for Rear View Monitor is Abnormal

DESCRIPTION

The video signal from the rear television camera assembly is transmitted to the radio and display receiver assembly.

WIRING DIAGRAM

A01V0JUE05

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)


    1. Disconnect the F70 radio and display receiver assembly connector.

    2. Disconnect the P2 rear television camera assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F70-16 (V-) - P2-2 (CV-) Always Below 1 Ω
      F70-8 (V+) - P2-3 (CV+) Always Below 1 Ω
      F70-15 (CGND) - P2-5 (CGND) Always Below 1 Ω
      F70-7 (CA+) - P2-6 (CB+) Always Below 1 Ω
      F70-16 (V-) - Body ground Always 10 kΩ or higher
      F70-8 (V+) - Body ground Always 10 kΩ or higher
      F70-15 (CGND) - Body ground Always 10 kΩ or higher
      F70-7 (CA+) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY


    1. Reconnect the radio and display receiver assembly connector.

    2. A01V208E02
      Text in Illustration
      *a

      Component with harness connected

      (Radio and Display Receiver Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F70-16 (V-) - Body ground Always Below 1 Ω
      F70-15 (CGND) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      F70-7 (CA+) - F70-15 (CGND) Within 60 seconds of turning the ignition switch ACC 5.5 to 7.05 V

    NG

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY Click here

    OK

  3. CHECK REAR TELEVISION CAMERA ASSEMBLY


    1. Reconnect the rear television camera assembly connector.

    2. Check the waveform of the rear television camera assembly using an oscilloscope.

      A01UYKQE02

      Tech Tips

      A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected.

      OK
      Waveform is as shown in the illustration.
      Item Content
      Terminal No. (Symbol) F70-8 (V+) - F67-7 (GND1)
      Tool Setting 200 mV/DIV., 50 μsec./DIV.
      Condition Ignition switch ON (IG), shift lever in R

      Tech Tips

      The video waveform changes according to the image sent by the rear television camera assembly.

      Text in Illustration
      *a

      Component with harness connected

      (Radio and Display Receiver Assembly)
      *b Waveform 1 (camera lens is not covered, displaying an image)
      *c Waveform 2 (camera lens is covered, blacking out the screen)
      *d Synchronization Signal
      *e Video Waveform

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPLACE REAR TELEVISION CAMERA ASSEMBLY Click here