NAVIGATION SYSTEM Display Signal Circuit between Radio Receiver and Extension Module

DESCRIPTION

The circuit sends a display signal from the extension module to the radio and display receiver assembly.

WIRING DIAGRAM

A01V16WE04
*a Extension Module
*b Radio and Display Receiver Assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE)


    1. Disconnect the V3 radio and display receiver assembly connector.

    2. Disconnect the V1 extension module connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      V3-12 (R) - V1-7 (R) Always Below 1 Ω
      V3-11 (G) - V1-23 (G) Always Below 1 Ω
      V3-10 (B) - V1-6 (B) Always Below 1 Ω
      V3-7 (HSYN) - V1-22 (HSYN) Always Below 1 Ω
      V3-6 (VSYN) - V1-5 (VSYN) Always Below 1 Ω
      V3-8 (AGND) - V1-20 (AGND) Always Below 1 Ω
      V3-12 (R) - Body ground Always 10 kΩ or higher
      V3-11 (G) - Body ground Always 10 kΩ or higher
      V3-10 (B) - Body ground Always 10 kΩ or higher
      V3-7 (HSYN) - Body ground Always 10 kΩ or higher
      V3-6 (VSYN) - Body ground Always 10 kΩ or higher
      V3-8 (AGND) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR