NAVIGATION SYSTEM Vehicle Speed Signal Circuit between Radio Receiver and Extension Module

DESCRIPTION

The extension module receives a vehicle speed signal from the radio and display receiver assembly and information from the navigation antenna, and then adjusts vehicle position.

WIRING DIAGRAM

A01V0RXE14
*a Extension Module
*b Radio and Display Receiver Assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE)


    1. Disconnect the V3 radio and display receiver assembly connector.

    2. Disconnect the V1 extension module connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      V3-2 (SPDO) - V1-18 (SPDO) Always Below 1 Ω
      V3-2 (SPDO) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR