FRONT DOOR SPEAKER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the RH side.

PROCEDURE


  1. REMOVE FRONT ARMREST BASE UPPER PANEL

    Click here

  2. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  3. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    1. A004G7L

      Disconnect the connector.

    2. A004EC7

      Using a drill bit with a diameter of less than 4 mm (0.16 in.), remove the 3 rivet heads as shown in the illustration.

      CAUTION:

      Be careful. The cut rivet is very hot.

      Note

      Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Disengage the claw and guide to remove the front No. 1 speaker assembly.

    5. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.