STEERING COLUMN ASSEMBLY(for RHD) INSTALLATION

PROCEDURE

1. INSTALL STEERING COLUMN ASSEMBLY

   
   

   1. Install the steering column assembly to the instrument panel reinforcement assembly with the 2 nuts and bolt.

      Torque:

      Bolt

      36 N*m  { 367 kgf*cm, 27 ft.*lbf }

      Nut

      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

      Note

      Be sure there is no interference around the wire harness.

   2. Connect all the connectors and engage all the wire harness clamps to the steering column assembly.

   3. Connect the 2 steering column assembly connectors to the power steering ECU assembly.

   4. Engage the wire harness clamp to the power steering ECU assembly.

2. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY

   Click here

3. INSTALL COLUMN HOLE COVER SILENCER SHEET

   
   

   1. Install the column hole cover silencer sheet with the 2 clips.

4. INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY

   Click here

5. INSTALL TRANSPONDER KEY AMPLIFIER (w/o Power Switch)

   Click here

6. INSTALL COMBINATION SWITCH ASSEMBLY

   
   

   1. Install the combination switch assembly to the steering column assembly with the clamp.

   2. Connect all the connectors to the combination switch assembly.

7. INSTALL UPPER STEERING COLUMN COVER

   
   

   1. Engage the claw to install the upper steering column cover.

8. INSTALL LOWER STEERING COLUMN COVER

   
   

   1. Engage the 4 claws to install the lower steering column cover.

   2. Install the 3 screws.

9. INSTALL STEERING COLUMN COVER SUPPORT (w/ Power Switch)

   
   

   1. Engage the 4 claws and install the steering column cover support.

10. POSITION FRONT WHEELS FACING STRAIGHT AHEAD

11. ADJUST SPIRAL CABLE

    Click here

12. INSTALL STEERING WHEEL ASSEMBLY

    Click here

13. INSTALL STEERING PAD

    Click here

14. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

15. INSPECT SRS WARNING LIGHT

    Click here

16. PERFORM CALIBRATION OF TORQUE SENSOR ZERO POINT

    Click here