| DTC Code | DTC Name |
|---|---|
| C1582 | Assist Map Number Mismatch |
DESCRIPTION
When an incorrect power management control ECU is installed after the assist map has been written the power steering ECU assembly, then DTC C1582 is stored because the data does not match the vehicle specifications.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1582 | Assist map number mismatch |
|
CAUTION / NOTICE / HINT
Note
If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration Click here.
PROCEDURE
CHECK CAN COMMUNICATION SYSTEM
Check for DTCs Click here.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
| B |
|
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITHTROUBLESHOOTING) Click here |
| A |
|
CHECK RELATED PART (POWER MANAGEMENT CONTROL ECU)
Check if any of the parts listed below have been replaced with an incorrect part in the past.
| Related Part | Power management control ECU |
Note
When removing a related part to check it, be sure to follow the appropriate procedures and precautions.
Refer to the following procedures to remove the power management control ECU Click here.
Tech Tips
DTC C1582 is stored when a part with an incorrect part number is installed for the related parts listed above.
When DTC C1582 is output when parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.
| Result | Proceed to |
|---|---|
| All installed related parts have correct part number (for LHD) | A |
| All installed related parts have correct part number (for RHD) | B |
| Part with incorrect part number is installed | C |
| A |
|
REPLACE POWER STEERING ECU ASSEMBLY Click here |
| B |
|
REPLACE POWER STEERING ECU ASSEMBLY Click here |
| C |
|
REPLACE RELATED PART WITH PART THAT HAS CORRECT PART NUMBER |