REAR BRAKE INSPECTION

PROCEDURE

1. INSPECT PAD LINING THICKNESS

   

   Text in Illustration

   *1

   Ruler

   
   

   1. Using a ruler, measure the pad lining thickness.

      Standard thickness
      9.0 mm (0.354 in.)

      Minimum thickness
      2.0 mm (0.0787 in.)

      If the pad lining thickness is equal to or less than the minimum thickness, replace the disc brake pad kit.

2. INSPECT DISC THICKNESS

   

   Text in Illustration

   *1	Micrometer

   
   

   1. Using a micrometer, measure the disc thickness.

      Standard thickness
      9.0 mm (0.354 in.)

      Minimum thickness
      7.0 mm (0.276 in.)

      If the disc thickness is less than the minimum, replace the rear disc.

3. INSPECT DISC RUNOUT

   
   

   1. Check the bearing play in the axial direction and check for the axle hub runout Click here.

   2. Tighten the disc with the 4 nuts.

      Torque:

      103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

   3. 

      Text in Illustration

      *1	Dial Indicator

      Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the rear disc.

      Maximum disc runout
      0.15 mm (0.00591 in.)

      If the runout exceeds the maximum value, change the installation positions of the disc and axle to make the minimum runout. If the runout exceeds the maximum even when the installation positions are changed, grind the disc. If the disc thickness is less than the minimum, replace the rear disc.