FRONT BRAKE FLEXIBLE HOSE INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.

  • If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure listed is for the LH side.

PROCEDURE


  1. INSTALL FRONT FLEXIBLE HOSE


    1. A01UZBTE01
      Text in Illustration
      *a Lock Hole

      Install the front flexible hose with a new union bolt and a new gasket.

      Torque:
      30 N*m  { 310 kgf*cm, 22 ft.*lbf }

      Tech Tips

      Install the front flexible hose lock securely into the lock hole in the disc brake cylinder.

    2. Install the front flexible hose and the speed sensor with the bolt.

      Torque:
      29 N*m  { 300 kgf*cm, 22 ft.*lbf }

      Note

      Install the front flexible hose and the speed sensor without twisting them.

    3. A01V0K4E02
      Text in Illustration
      *a Identification Mark

      Install the front flexible hose with a new clip.

      Note


      • Install the clip as far as it will go.

      • When installing the front flexible hose, face the identification mark to the outside of the vehicle and minimize twisting of the hose.

    4. Using a union nut wrench 10 mm, install the brake tube to the front flexible hose while holding the front flexible hose with a wrench.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

  2. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  3. BLEED BRAKE LINE

    Click here

  4. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }