FRONT BRAKE FLEXIBLE HOSE REMOVAL

CAUTION / NOTICE / HINT

Note

If both left and right hoses are disconnected at the same time, be sure to place identification marks indicating the position on each side.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure listed is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here

  2. DISABLE BRAKE CONTROL

    Click here

  3. REMOVE FRONT WHEEL

  4. DRAIN BRAKE FLUID

    Note

    Immediately wash off any brake fluid that comes into contact with any painted surfaces.

  5. REMOVE FRONT FLEXIBLE HOSE


    1. A004E5P

      Using a union nut wrench 10 mm, separate the brake tube while holding the front flexible hose with a wrench.

      Note


      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting position.

    2. Remove the clip.

    3. Remove the bolt and separate the front flexible hose and the speed sensor.

    4. A004E6H

      Remove the union bolt, gasket and the front flexible hose from the disc brake cylinder assembly.